Cartridge Heater Order Pricing Information Form

Heating Application:
Dalton Part Number (if known): Quantity:

Sheath Diameter: 1/4 in 3/8 in 1/2 in 5/8 in 11/16 in 3/4 in 1 in 8.0 mm 10.0 mm 12.0 mm 12.5 mm 15.0 mm 16.0 mm 20.0 mm
Sheath Length:
Bore Inside Diameter:

Sheath Style: standard sheath
grooved sheath (for use with thermocouple)

Temperature Requirements Fahrenheit Celsius
Manufacturing Process Temperature:
Set point Temperature:
Wattage: Voltage:

Wattage Distribution: Hot Tip Cool Tip
Variable Zones of Heat Along Sheath
If Variable Zones of Heat, please describe:


External thermocouple required with heater? yes no

Operating Conditions
Frequency of Cycling:
(If heater is regulated by controller)

Are lead wires subject to severe flexing? Yes No
Is heater subject to severe ambient conditions such as dripping oil, wash down, etc.?
Yes NoIf yes, please describe conditions:

Heater Accessories and Options (Check all that apply)

Abrasion Resistance
Stainless Steel Braid Stainless Steel BX
Straight Header Right Angle Header

Contaminant Protection
RTV Potting Ceramic Potting

Lead Modifications
Extra Length Lead. Specify Length:
Threaded Post Terminals
Fiberglass Sleeving
Silicon Rubber Sleeving
Quick Disconnect
Clip Support
Integral Ground Wire
Nickel Ring Terminals

High Temperature Modifications
High Temperature Leads
Extra Cold Section at Terminal End
Ceramic Beads

Mounting Options
Stainless Steel Flange
Puller End Plug
Mounting Bracket
NPT Fitting (Replaceable Immersion Heater)
Solder Pin Connectors

Special Considerations
If you have special heating requirements, please describe:

Your Contact Information: (*indicates required field)

How would like us to contact you? phone fax email mail

How did you learn about Dalton Electric?